• BAST LED Driver can work on Triac, 0-10V & PWM dimmer, consult compatibility before use, Non compatible dimmer switch may cause audible noise, flickering and higher light output when the dimmer is set at a certain level.

 

• Maximum total LED lamps power should not exceed 20% of dimmer’s maximum rated power.

 

• For instance, if a dimmer’s maximum rated power is 600 Watts, the recommended maximum LED lamp load power should be under 120 Watts.

 

• The time it takes to turn on the light may vary with different king of dimmer switch.

 

• When the dimmer is tuned at the lowest lever, dimming or flickering might occur when a high-power consumption device such as hair dryer or air conditioner is used due to power and current fluctuation.

 

• When turning off light, it is highly recommended to turn off the power switch instead of simply tuning the dimmer to the lowest level.

 

• It is normal to have minor noises when turning dimmers.

 

• If the light flickers when dimming, please adjust the dimmer until the light is tuned to a steady level.

 

BAST LED驱动器可以在双向可控硅，0-10V和PWM调光器上工作，使用前请先咨询兼容性。如果将调光器设置为一定水平，不兼容的调光器开关可能会导致听得见的噪声，闪烁和更高的光输出。

LED灯的最大总功率不应超过调光器最大额定功率的20％。

例如，如果调光器的最大额定功率为600瓦，则建议的最大LED灯负载功率应低于120瓦。

开启灯光所需的时间可能会随着调光开关的不同而变化。

当调光器调到最低档时，由于功率和电流波动，使用吹风机或空调等高功耗设备时，可能会发生调光或闪烁。

关灯时，强烈建议关闭电源开关，而不是简单地将调光器调到最低水平。

转动调光器时，通常会有轻微的噪音。

如果调光时灯光闪烁，请调节调光器，直到调到稳定的水平。